PIC18F2610-E/SO【PDF 72/234 页】IC MCU FLASH 32KX16 28SOIC

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录3878

68页 69页 70页 71页 [72页]73页 74页 75页 76页

2009 Microchip Technology Inc.

DS39636D-page 165

PIC18F2X1X/4X1X

REGISTER 16-5:

SSPCON2: MSSP CONTROL REGISTER 2 (I2C MODE)

R/W-0

GCEN

ACKSTAT

ACKDT

ACKEN(1)

RCEN(1)

PEN(1)

RSEN(1)

SEN(1)

bit 7

bit 0

bit 7

GCEN: General Call Enable bit (Slave mode only)

1 = Enable interrupt when a general call address (0000h) is received in the SSPSR

0 = General call address disabled

bit 6

ACKSTAT: Acknowledge Status bit (Master Transmit mode only)

1 = Acknowledge was not received from slave

0 = Acknowledge was received from slave

bit 5

ACKDT: Acknowledge Data bit (Master Receive mode only)

1 = Not Acknowledge

0 = Acknowledge

Note:

Value that will be transmitted when the user initiates an Acknowledge sequence at

the end of a receive.

bit 4

ACKEN: Acknowledge Sequence Enable bit (Master Receive mode only)(1)

1 = Initiate Acknowledge sequence on SDA and SCL pins and transmit ACKDT data bit.

Automatically cleared by hardware.

0 = Acknowledge sequence Idle

bit 3

RCEN: Receive Enable bit (Master mode only)(1)

1 = Enables Receive mode for I2C operation

0 = Receive Idle

bit 2

PEN: Stop Condition Enable bit (Master mode only)(1)

1 = Initiate Stop condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Stop condition Idle

bit 1

RSEN: Repeated Start Condition Enable bit (Master mode only)(1)

1 = Initiate Repeated Start condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Repeated Start condition Idle

bit 0

SEN: Start Condition Enable/Stretch Enable bit(1)

In Master mode:

1 = Initiate Start condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Start condition Idle

In Slave mode:

1 = Clock stretching is enabled for both slave transmit and slave receive (stretch enabled)

0 = Clock stretching is disabled

Note 1: For bits ACKEN, RCEN, PEN, RSEN, SEN: If the I2C module is not in the Idle mode,

these bits may not be set (no spooling) and the SSPBUF may not be written (or

writes to the SSPBUF are disabled).

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit, read as ‘0’

-n = Value at POR

‘1’ = Bit is set

‘0’ = Bit is cleared

x = Bit is unknown

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式